camera mover using dmx

Back

Hello Aximmetry

Will you please give me some tip how to make camera mover using external dmx console?

I know arnet configure but don't know how/which one to assign dmx data to camera position and roll data.

Thanks in advance.

Bruce

brucekim

Comments

Zoltan@Aximmetry

Hi Bruce,

I'm not sure you have to assign the DMX to a Camera Mover, because it does not allow absolute positioning from an external source. For that you have to replace the camera transformation itself (which normally comes out from a Camera Mover, but it can be assembled any other way).

E.g. you can assemble a camera transformation like this:

Setup the proper value ranges for each Dash Scalar (e.g. 0 - 360 for Y rotation etc.)

Now you can assign the desired DMX controls to the In property of each Dash Scalar.

I'm not sure this answers your question, please let me know.

brucekim

Hi Zoltan

Thanks a lot for your response. This gives me a clue how I can do.

Thanks again and Regards

Bruce

Zoltan@Aximmetry

Hi Bruce,

I'm sorry, a quick correction: Rotation should be done BEFORE the Translation, so please connect the two modules in reversed order. Sorry for the mistake.

brucekim

Oh, OK.

Many Thanks!

camera mover using dmx

Comments

Cookie consent