Behringer USB Audio Interface

Hi Community,

I have been trying for a while to run audio via a Behringer UMC404HD. However no success whatsoever. It is working fine in all other apps but Aximmetry. I am able to select the interface in aximmetry but no audio is going in to the system. Any suggestions?

Thanks,

Ulf

Malibuswede

laislafilmes

News?

I also have the same audio interface, would you like to know if it works with Aximmetry?

Malibuswede

Hello all,

I got it to work perfectly. There is one issue. If the delay is set higher than 0.24, at each launch of Aximmetry I have to change it to below 0.24 and then just bring it back up to whatever delay is desired. For my setup, a frame-accurate delay is 0.31. I have also made a conscious choice of going for the highest buffer size in the Behringer control panel, 2000 samples. The sound is much cleaner compared to the many conversions and long cable runs we had before by going from the soundboard and embed in the SDI signal.

;

Behringer USB Audio Interface

Cookie consent