Antilatency stops tracking aft | Forum

Antilatency stops tracking after 1-2 mins

Hi I'm using Antilatency with the latest Aximmetry DE.

I've noticed that when I select Antilatency as tracking device, it would only work for 1-2 mins (the led light is green), after that, there's just no tracking, and the led light on the tracker will go back to blink mode. And Aximmetry can not find Antilatency tracker in the list. I have to replug in the usb for the tracker, then it could be used again for just a few minutes.

Without openning Aximmetry, I observe it with Antilatency's own service software, it'll stay in the device tree for no problem. But if the tracker stops working in Aximmetry, when I reopen the service software, the device tree will vanish as well.

And sometimes after the Antilatency stuff stops working, when I try to access the device list in the INPUT panel, Aximmetry will crash.

Rogerfuntoo

I did some further test, under following circumstances Aximmetry will crash when trying to open the tracking device list:
1. if I connect more than one ATL tracker, when I try to change the tracking device

2. If I disconnect all the ATL tracker

Aximmetry

Hi,
Could you create and send us the dump files for all these crashes to support@aximmetry.com? Thank you.

Regarding the disappearance of trackers, I'm not sure it's an Aximmetry-specific bug. Can be a driver or firmware compatibility issue.
Could you try it with other software? E.g. with their Unreal plugin?

emre_serim

hi,

do you use Antilatency wired or wirelessly?

Aximmetry

Hi Roger,
We identified a possible cause for Antilatency crashes. It will be fixed in the next release.
I'm not sure yet if it's linked to the vanishing of trackers, you'll have to do tests.

Antilatency stops tracking after 1-2 mins

Cookie consent