Hello,
We are experiencing an issue with the timecode and latency. We are using an external timecode and have followed the entire procedure by enabling the master timecode in the input and setting "use master TC" in the Record_3-Audio section. However, when we start recording, the following error appears... 
We have noticed that by entering the Record_3-Audio section and changing the value from "realtime" to "25p," the correct frame rate we need, we no longer encounter timecode issues. However, a latency error occurs that we cannot resolve even by increasing the latency in the video input preferences.
Is there any way to resolve these issues, perhaps by keeping the recorder in realtime but fixing the timecode problem, or by resolving the latency issue?
Our goal is to record the camera tracking data by integrating the timecode into the FBX and having a preview of the footage.
We kindly await your prompt response.
Best regards,
Hi,
You must keep the Frame Rate pin of the Video Recorder module in Realtime unless you are in post-production and you do not have any live input. Instead, you need to set the Frame Rate in Edit > Preferences > Rendering to match your master timecode INPUT's frame rate. Detailed information on both the Rendering setting's Frame Rate and the Video Recorder's Frame Rate can be found here: https://aximmetry.com/learn/virtual-production-workflow/preparation-of-the-production-environment-phase-i/inner-workings-of-aximmetry/rendering-settings/#introduction
If recording with timecode still does not work while the Rendering setting's Frame Rate matches your input's frame rate, then you can debug by using a Video Input module. In the Video Input module specify Device and then check its Frame Rate pin. Additionally, you can write out its timecode like this:
Warmest regards,