Hello! I'm working on the Antilatency in aximmetry, then after the cam calibration, my virtual floor doesn't show up after calibration, so as my cur position don't receive any signal from camera movement.
Someone know how to fix that? What issue could be?
Hi,
You probably didn't see the floor cause the camera's origin position was under it in height. Or you had these turned off:
Since antilatency doesn't save a zero point, we suggest using the Detect Origin option in the ORIGIN panel to set the correct height. Currently, this button is only documented under the Aximmetry Eye documentation's Using the Aximmetry PC paragraph. You should be able to use the ArUco marker and the Detect Origin with Antilatency just as well.
In the case of Cur position not showing in Aximmetry, make sure you exit the Camera Calibrator program before opening the Aximmetry Composer. Antilatency trackers can not be used simultaneously by multiple programs on your computer.
Warmest regards,