The antilatency and hardware devices we have connected through Bluetooth have been identified, and the data in aximmetry are all in motion.

After we use antilatency, the biggest problem now is calibration. There has never been a successful calibration. It has been 2 days, 1 meter origin, 1 meter forward. I have to rotate the scene in aximmetry, but the ground is still not fitted to the scene. There are too many problems. Now the calibration and fit is a big problem. Do you have any solutions? It's mainly a calibration problem, it doesn't fit the ground, thank you

Hi,

There is a video tutorial for the origin positioning:

Here: https://www.youtube.com/watch?v=C8MZ7g0Czrc

However, note that you will need two trackers for this. If you use or move the alt tracker on your camera, then you ruin the calibration file's tracking calibration.

You can also correct the camera's height in the ORIGIN's Delta Cam Transf:

By the way, it says your tracker is about 1.5 meters from the floor:
That could be close to the real value. Are you sure it is the floor position that goes wrong?
Note, the above Current Position value doesn't include the calibration file, so it will display your Alt tracker's position and not your camera's exact position.

Warmest regards,

Thank you, we will test again when we are free these two days, thank you for your reply in your busy schedule