We are using DeckLink 8K Pro Card to input /output Video in Aximmetry software.
Our problem that when we switching from port to port the software sometimes show the following error message
Can you please fix this problem?
We are using DeckLink 8K Pro Card to input /output Video in Aximmetry software.
Our problem that when we switching from port to port the software sometimes show the following error message
Can you please fix this problem?
when aximmetry will fix this problem?
I think this problem happened when switching on SDI video input using alpha animation
Also in 2020.4.1 the software force close without showing any error messages sometimes and sometimes it show same error message.
Can you please fix this problem ?
Because we are planning to use aximmetry software on live shows and this bug stop us from doing that.
We have installed Blackmagic desktop Video 11.5.1 driver to see if this can help in solving our problem as they mentioned a bug that is similar to what we have
You wrote "SDI video input using alpha animation".
Can I ask what did you mean exactly? Thank you.
We are using simple template which have sdi input as its background and this template is animated so it have in/loop/out animation
This problem happened randomly .
When you switch between ports, is that mean:
- you change the Device property of a Video Input module
- or you have multiple Video Input modules and you switch between them via a Switch Video
Do you also use audio input from these inputs?
we didn't changed the switch module inputs or audio but sometimes we change the device property of video input module.
Unfortunately we still cannot reproduce the crash.
But now that you use the 5.1 version, can I ask you to create and send us a dump when the crash occurs? Thank you.
We have tested Aximmetry 2020.5.1 on our Studio PC for sometime and I think that we don't have this problem now.
We will keep monitoring this problem and see if everything is ok
Side note, Its seems to me that there is some performance improvement when using aximmetry 20.20.5.1.
So ,Thank you aximmetry
We’re still geting crashes in 2020.5.1. This happens for both NDI and SDI source. Just switching between them crashes Aximmetry. It seems to happen especially when we activate (or switch to) an input for the first time. After a restart we can often switch to it again without a crash, and then it seems to stay fine. Not sure what’s going on but I’m saving the crash logs and will send them ASAP.
Thank you for reporting. We will investigate and fix it in our future releases of Aximmetry.