Control lighting equipment via | Forum

Control lighting equipment via DMX ArtNet

Back to Posts

Hello,

I need to control lighting equipment but I can't find where I can fill the IP address and port to send DMX values.

As you can see in DMX Out I can't find Arnet to fill that config.

I'm using "The ArNetominator" software but that app. is not populated like an Arnet node.

I was able to receive DMX but not to send.

Thanks in advance and best regards,

Sergio Gómez

Eifert@Aximmetry

Hi,

When using DMX Out module, such IP addresses are automatically detected and listed:

You set in the Manage Devices the network adapter, the (internal or external) device that is connected to the local network. On this network adapter, Aximmetry looks for ArtNet.

In your case, you set the network adapter of the wireless network:

So if the DMX is connected through a network cable to your computer and not through the WIFI, then you will have to change this to a different adapter.

Warmest regards,

;

Control lighting equipment via DMX ArtNet

Cookie consent