The Keyer seems to forget the path where the cleanplate has been stored
when Axy is restarted or the scene is loaded again, which results in a Billboard output like this:
Although the path to the cleanplate has benn set numerous times and the scene has been saved as well,
we have to manually assign the cleanplate every time.
Looks as if Axy stores the path to where the cleanplate was generated initially rather than the one we assign manually.
Cheers.
Eric.
Hi Eifert.
Ah...I see.
Makes sense to a certain extent that if we leave edited compounds open (i.e. not saving the modifications) the filepath is not saved either.
So probably we specified the original capture with an unedited compound, and went into editing later on which then resulted in the new settings not getting saved...
Cheers.
Eric.
Hi Eric,
Even if the compound is opened for edit or unlinked it should keep the changes.
What I was thinking in the previous comment, was that when you opened the compound you also edited it somehow which causes this behavior. Like connecting something to the Clean Plate pin:
Of course, you need to save the whole compound (CTRL+S) after changing the clean plate to keep the change.
Warmest regards,
Hi Eric,
This is probably the result of some editing in the flow editor of the keyer. It does not happen with unedited camera compounds.
Note, I know the keyer is edited from the % sign:
Also, when pressing Capture, the location is not written into the Clean Plate pin. You have to specify it. This is a lost functionality that will be fixed in a future Aximmetry release.
Warmest regards,