Antilatency 2021.3.2 Error

Back to Posts

Hi!

In 2021.3.2 (clear installation with unnistall of old antilatency service and install new one 3.3.0 or 3.2.0 Service) i'm facing issue with tracker causing position and rotation changes automaticly on hardfixed tracker (it's not tipycal antilatency issue with small drift) - if exposing rotation and position by clicking on transformation line going from camera tracker node with CTRL holded i can see transformation(rotation) of tracker goes increasing automaticly. If install 2021.3.1 - everything goes ok.

Last updates have been installed both trackers and sockets. Not depending of different tracker and sockets (i've tried diffrent ones).

Alexander Zhivykh

Ahmed@Aximmetry

Hello Alexander,

to be sure, please check whether you have AntilatencyService 11 installed or any old version of AntilatencyService (3.1 or lower) installed.

Only 3.3 should be running on your machine for it to work correctly.

Alexander Zhivykh

Hello Ahmed!

I've double checked diffrent PC (fresh installation of Aximmetry and antilatencey service)

Here is Antilatency version image and Antilatency results with 2021.3.2 (tracker is hard fixed and stay still, but coordinates (in most R (rotation) goes changes and it's not a kind of tipycal drifting).

https://drive.google.com/drive/folders/1djKEFohZdchBqDjCav2s0W4UAP5z5x3v?usp=sharing

with 2021.3.1 no problems at all

Eifert@Aximmetry

Hi Alexander,

We also noticed a similar issue.

When it happens again, please try restarting the tracker (Alt), you can just disconnect it from the USB and reconnect it. If that helps, please write back to us.

Warmest regards,

Antilatency 2021.3.2 Error

Cookie consent