Blackmagic SDI input AUTO mode

Hello

I just found that AUTO mode of Blackmagic capture board doesn't work properly.

In my case, the camera input is set to 1080p59.94 and Blackmagic Desktop shows 1080p59.94.

But the rendered output video keeps fast stuttering which is similar to downgrading 1080i resolution.

So I switched AUTO to 1080p59.94, and render output is clear after that.

Hope you check this out.

Bruce

brucekim

Zoltan@Aximmetry

Hi Bruce,

Could you tell me

- which exact BM model do you use?

- what framerate Aximmetry reports when you choose AUTO?
You can check it by peeking the Frame Rate and Interlaced output pins of Video

Also please make sure the Aximmetry rendering framerate equals to the input framerate in order to avoid stuttering.

;