Hi everyone,
Recently, I also tested with the LED wall and enabled digital extension. But, I wonder if the digital extension supports moving and rotating the camera? Please refer to the attached image. With tracking system REtracker, in center the result is good (image 1), but when I'm rotate physics camera and have two problems (image 2):- View angle in LED and digital extension mismatches.- Virtual panel using calib with the physics LED always sticks in front camera view, and it causes the appearance of the image outside the LED wall.
Any suggestions for this problem?
Many thanks!
Hi!
Yes, the digital extension supports moving and rotating the camera.
We suspect two ways this problem might happen.
One that your REtracker system was turned off while you moved your camera. Make sure that REtracker is always online while using aximmetry and that at startup of Retracker and aximmetry your led wall is at the correct place. REtracker recalculates its starting point each time you turn it off/on so after each turn on you have to set the led wall's position again.
The other one is that your virtual led wall's position and rotation were not the same as the real-world one. You might have been able to position the led wall in aximmetry to look good from that one camera rotation and position, but if the led wall's transformation positions are not the same as the real-world values, then your setup will be misaligned once you move or rotate the camera.
Best Regards