Hi,

You can match colors using LUT and Vignette, more about this here: https://aximmetry.com/learn/virtual-production-workflow/led-wall-production/using-led-walls-for-virtual-production/#lut

Warmest regards,

Hi

when i make it in LUT MEASURE  it shows like this

then what can I do with this

thanks

Hi,

It is likely that it is not progressing further due to the artifacts visible in your image:

I don't know what could cause this kind of artifact, maybe there are gaps between the LED wall panels?

Also, note that the LUT measurement function is quite sensitive. Make sure to carefully read and follow all the tips displayed when launching the LUT measurement option.

If it still does not work, the issue might be related to inaccurate lens calibration. You can observe this in the corners of your image, where the placement of the helper graphics—the gray rectangles—appears more distorted than the blue gridlines on the LED wall:

Did you perform the lens calibration using the Aximmetry Camera Calibrator?

Warmest regards,

Hi 

I also don't know what is this

I did perform the lens calibration whit the Aximmetry Camera Calibrator

I am using a big TV as the LED WALL,it's one big screen about 1.75m x 0.95m,should I write it blow like this ？

And I find this  

after I turn it on， it shows like this

is this Vignette Compensation？ cause I can't find it under Inputs Control board \ Input (n) ，

if it is then where  can I get the  marker 

thanks